How to Make Steps Out of Pavers

Do you want to know how to make steps out of pavers? Are you looking for easy but achievable ways to do it without external help? Yes, you can do it without much effort. You just need to know the ingredients and ways to achieve the end result. Paving stones are considered great to get the required support for outdoor installations. These stones can protect your retaining walls, walkways, and decks from harsh weather and normal wear and tear.

How to Make Steps Out of Pavers — Paver Step Installation

Paving stones are available in different designs and shapes. You can choose any design depending on your preference. But, choose the right one to get the required support. To start making steps out of pavers, consider the following:

Step One

Start your project by digging the area where the first step installation is done. Make sure that the hole is eight inches deep. The compacted area width might not the same depending on your intended step size. Now you will need a hand tamper or plate compactor to compact the subsoil. It will help you to create a flat surface.

Step Two

Get landscape fabric to cover that hole. This is essential to support rainwater drainage under your steps. Now you will need crushed stone aggregate to cover the landscape fabric. Use a ¾-inch layer and then compact it well. By doing so, you can create a flat and stable surface required to install the step.

Step Three

You will need one part of Poland cement and two parts dampened sand to make a thick paste. If you’re wondering how much sand you’ll need, it depends on the total space you’ll be laying pavers. Mix these ingredients well and then apply a ¼-inch layer of that mixture on the base material’s top. Now you will have a flat surface that you can use to install pavers.

Step Four

After creating a flat and stable surface, you need to set the first course of pavers onto that mixture. While doing so, it is important to check the level. You have to check the level after setting every stone to make sure that it fits flat against each other and against the ground as well.

Step Five

Once it is done, cut one inch in the second level of the first pavers to create staggered joints. This method will offer great structural support to the steps. Also, you will need a diamond-blade wet saw or a mallet to cut the stone. Decide your cutting tool depending on the stone type. Continue to make staggered joints and create upward joints to get the required height for the step.

Step Six

Get sand and spread a layer of sand over the paver step top. Now sweep the sand into your pavers’ joints. Sand will make your paver strong while offering better structural support. You can tamp or compact the surface of your steps to compact the sand.

Bottom Line

Now you know how to make steps out of pavers. This is simple and cost-effective. You can do it without taking professional help. You just need to follow the above steps and make sure that you are using the right material and the right quantity to get the best outcome.